-
Hello Tertius,
First of all, thank you for your work and developing this software.
After managing to configure the MQTT server this is what I am getting when trying to connect to my control panel.
…
-
Hi,
I am using a Wemos D1 Mini Pro and a buck converter connected to the Gnd and + serial pins of the MG5050 alarm system. I have properly soldered the pins and checked the connections several time…
-
hello, I have this Warning in log:
WARNING - PAI.paradox.hardware.panel - Unable to properly decode label b'Sens.Scale 1\xd2 P' using the utf-8 encoding.
Specify a different …
-
I have a latest PAI installed as a Hass-io add-on, and I have been using it with satisfaction for months. Installed PAI: 2.2.3
My country is Hungary, and my Hass-io date is:
~ $ date
Tue Oct 27 13:…
-
## **evo48 and or mg5050 same issue on both even defaulted**
## **Windows HyperV**
## Hey after uploading config below to my esp32s board connecting serial as per instructions im getting erro…
-
Hello, I'am trying to intergrate this to my openhab2 setup at home, and having issues with the physical connections including the resistors and pins, could you provide some sourt of schematics?
The c…
-
Hi,
First of all, thank you for taking the time to share ParadoxAlarmInterface!
I'm trying to connect my alarm (Using the Home Assistant addon) but I didn't managed to solve the following issue.…
-
Hello,
I have a Paradox 1759EX alarm and I flashed a Nodemcu ESP8266 with ParadoxAlarmSystemOTA.ino
I connected RX/TX and Ground between the Paradox board and the ESP8266 relevant pins.
The Nodem…
-
Hello @jpbarraca good evening,
I do not know if I am writing in the correct place because I am very new to all of this and I intend to use your interface with my MG5000 alarm system. Could you prov…
-
## Alarm system
MG 5050 with ip150 v4
IP connection with pai
## Environment
- RPI - docker..
- Python 3.7.2
## Git branch
Master and dev
## Describe the bug
After a couple of hours runnin…