-
My printer is equipped with a belay. I followed the wiki for its configuration and the correct information is displayed by the mmu_sensor command
(triggered when I compress the belay by hand)
co…
-
Hi!
I recognize that such functions are beyond the intent of this program, but as you are the one with the original code, I wanted to ask if there is a possibility to control the actual speed of th…
-
AS A Product Owner
I WANT TO have Motor vehicle tax service available in Bürokratt
SO THAT I can get information about Motor vehicle tax
### Acceptance Criteria
- [x] The chatbot must allow users to…
-
The current settings and limits coming from the Betaflight FC are being interpreted such that even with the PWM output at full, the motors are still not spinning enough to enable flight.
-
have a treadmill with damaged control board and the motor board pins are like I show in the photo I send... Any idea if your project can be connected and control this board? Thanks in advanced
have a treadmill with damaged control board and the motor board pins are like I show in the photo I sen…
-
have a treadmill with damaged control board and the motor board pins are like I show in the photo I send... Any idea if your project can be connected and control this board? Thanks in advanced
![12 …
-
I have a treadmill with damaged control board and the motor board pins are like I show in the photo I send... Any idea if your project can be connected and control this board? Thanks in advanced
![12…
-
Hey @alistair23 and all,
I understand that this request is not really in the interest of the project, but maybe you found something while scanning through the protocol.
The mower that I am look…