-
for example i have a board that has the following wiring scheme:
GPIO 0 = CS
GPIO 1 = DC / CMD
GPIO 2 = RESET
ADBUS1 - MOSI
ADBUS0 - CLK
how can i initialize both the GPIOS and the ADBUS pins …
-
This definitely worked a few months ago, but I've changed laptops since then and now it doesn't:
```
$ openFPGALoader -b tangnano9k --verbose-level=2 build/counter.fs
empty
Jtag frequency : requ…
-
I use the library with FT2232H chip ( http://www.ftdichip.com/Products/ICs/FT2232H.html ) which has two MPSSE interfaces.
Now only one is supported in the library, IFACE_A is hardcoded here:
https:/…
-
The mpsse implementation seems to be buggy. I cannot get this adapter to reliably work with OpenOCD. At times OpenOCD just hangs with the message "Haven't made progress in mpsse_flush()..."
This se…
-
Hey, thx for this good python module :)
I've one question: is it possible to switch dynamically between MPSSE mode and UART ?
Thx in advance.
-
there are several ftdi based jtag probes, like flyswatter2, bus blaster, xds100 and others
even all use same/similar chip, mpsse settings are different.
in pyftdi it is hardcoded. for example openoc…
-
```
Add this to prevent type issues in python when using types other than basic int.
```
Original issue reported on code.google.com by `robokni...@gmail.com` on 29 Nov 2013 at 4:25
Attachments:
- [m…
-
```
Add this to prevent type issues in python when using types other than basic int.
```
Original issue reported on code.google.com by `robokni...@gmail.com` on 29 Nov 2013 at 4:25
Attachments:
- [m…
-
```
Add this to prevent type issues in python when using types other than basic int.
```
Original issue reported on code.google.com by `robokni...@gmail.com` on 29 Nov 2013 at 4:25
Attachments:
- [m…
-
Gentoo amd64 Linux 3.18
autoconf (GNU Autoconf) 2.69
```
$ ls
configure.ac examples Makefile.in mpsse.c mpsse.h mpsse.i mpsse.py support.c support.h
$ autoconf
$ ls
autom4te.cache configure …