-
```html
MT3608 SEPIC Voltage Calculator
body {
font-family: Arial, sans-serif;
background-color: #f0f0f0;
}
.container {
max-width: 400px;
margin: 40px auto;
pa…
-
I just put together an Afterburner, and I had a heck of time trying to get it calibrated.
I eventually figured out that the MT3608 module that I was using had the wiper and low-side terminals of th…
meup updated
8 months ago
-
I built the latest version of the afterburner and I'm trying to use it to program some Lattice GAL16V8B chips. I'm using one of the newer MT3608 modules where I had to replace the 2.2K resistor with …
-
Built a PCB to the schematic but couldn't get the programming voltage to work.
Thought it may be the MT3608 module (modified as instructed) having some issues as other users on the web have claimed. …
-
I just built a DRAM tester with your PCB. Thanks for sharing. I came across an issue with the 12V DC-converter. If I connect the tester the proper way through the Arduino I get only about 5V out of th…
-
https://www.rcscomponents.kiev.ua/catalog/induktivnosti-drosseli-silovye-smd-na-gantele/557
https://www.rcscomponents.kiev.ua/product/mc34063acd-tr_12419.html
https://www.rcscomponents.kiev.ua/produ…
-
I realized that there is few sources of boards around internet for this purpose, and that is how I found this repo, amazing work I must say!
I think there would be a nice chance more people end up …
-
Hi, it is not clear to me in the schematic and in the Arduino example, if I can directly connect the logic of ADS1262 to 5V of my Arduino.
Do, I should open SJ1?
In the example there is written to…
-
I build something familiar with the same battery charger. But the TP4056 only provides the battery voltage. E. g. with 4.2V (fully loaded battery) and VCC connected to 5V Vin I can't read out the DHT2…
-
HI,
I'm using a different hardware and a different power supply solution to switch Vpp for the GAL (instead of the 5V/12V MT3608 module). Also my Hardware is a Arduino Nano instead o the Arduino UNO…