-
This issue was created in an effort to collect information about device support.
> See [my gist](https://gist.github.com/andersevenrud/e4637c0cbde665f72f864032e540aa5d) where I collect information …
-
So the device now shows up as an entity in HA but the sensor is always on (this is a Nexa issue aand not an issue with this HA implementation ) however it should still trigger a state change event eac…
-
UTELYS
-
As title says, I am wondering if it should be able to pick up on when I add a new device to my Bridge X. Usually I have to do this via their own app. And afterwords they don't seem to appear in Home …
-
Nexa devices are using 64-bit codes, but uart TX buffer is too small (48 at the moment) for sending those. Would it be too bad to handle the uart TX in a blocking way? I can make a pull request for th…
-
Using the right IP and nexa as username and password without success.
Nexa Bridge 3
2.5.8
 that Portisch firmware uses (advanced sniffing , stop advanced sniffing, bucket transmit, bucket sniffing) are not ava…
zd3sf updated
27 minutes ago
-
The device setup in HACS took a while, possibly due to a timeout issue, but eventually, it was configured with the correct IP address and in legacy mode. The Hub was successfully added and detected th…
-
I just wanted to let you know that I have a problem with using the latest v1.2.33 in Homebridge. It complains...
```
TradfriError: The gateway did not respond in time.
at TradfriClient. (/usr…
-
The KaKu range of switches uses a different RF433 protocol from the RemoteSwitch library.
There is a library to support this at https://bitbucket.org/fuzzillogic/433mhzforarduino/wiki/Home
**…