-
Hello Colleagues,
@AlexGyver Thank you for sharing this amazing library.
I'm using the 1.6.1 Gyveroled Arduino library version, but I'm facing problems with the Raspberry Pi Pico RP2040.
I'm…
-
I have encountered an issue with the newer CH1120 driver IC, which seems to be replacing the SH1108.
The OLED module looks absolutely the same, has the same pinout (SPI connection) and same resoluti…
-
had a few run-ins with some oled switches that just glitches too slow - takes a long time.
glitch pattern is
instant
instant
instant
40 seconds
60 seconds
80 seconds
instant
80 seconds
…
Leerz updated
1 month ago
-
Serial port WebSerial VendorID 0x1a86 ProductID 0x7523
Connecting...
ESP32
Chip is ESP32-D0WDQ6 (revision 1)
Features: Wi-Fi, BT, Dual Core, 240MHz, VRef calibration in efuse, Coding Scheme None…
-
Hello,
I have been working on a project that involves two OLED displays, both of the SH1106 type. One display has the I2C address 0x3C, and the other has 0x3D and both are connected to the same I2C l…
-
Als absoluter newbie, habe ich versehentlich einen Arduino Nano mit integriertem OLED Display gekauft.
In der Hoffnung Platz und auch Geld zu sparen wollte ich das eben etwas anders umsetzen - leider …
-
Hi,
I just build this device. Worked on first try! (nice job)
Sort of.
The OLED exists in multiple variants. I2C and SPI. While i bought the correct one 4pin, the pinout was VCC GND I2c i2c. Yo…
-
Any chance of getting a version of the pcb that adds an oled to the Reviung41 ala the Corne? The schematic looks like it has the right pins free on the MCU .. but my non-existent KiCAD skills are not …
-
## Description
The colors, especially black, on the Oculus Quest 1 seem to be somewhat off, with the biggest issue being that black is gray. This happens in game environments, as well as when the str…
-
error as below
6.5.0-valve19-1-neptune-65 is NOT supported. Exiting immediately.