-
- LED strips for signs/lamps at the workshop should be controlled based on a motion sensor
- LED strip in Prusa Enclosure should be controlled based on printing status. Maybe listen for events using …
-
Some Dynamixel motors spawned in our closet. This package has control boards that we can utilize. Begin working with these controls and interface with raspberry pi.
-
Confirm the following works:
- [x] Voltage divider outputs a voltage within the acceptable range for the pins
- [ ] pi can control LED ring
- [x] pi can talk to teensy
- [x] pi can control fan
…
-
| by mrd599@nci.org.au
___
Setup proper PI control configuration
___
_Issue migrated from [trac:330](https://accessdev.nci.org.au/trac/330) at 2024-01-31 18:30:36 +1100_
-
If I am understanding the README correctly, I should be able to run cnc.js on a Raspberry Pi that is attached to the GPIO header and communicate with Flexi-HAL. Is this accurate?
After following th…
-
Hi,
Thanks for library! 😊 I've used it in a Volumio plugin. It's been tested on a Pi 5 and Pi 4 and setting GPIO works fine. However, on my Pi Zero 2 and Pi Zero, setting GPIO doesn't seem to d…
-
@har917 and @rml599gh noticed that this variable isn't saved correctly (note that it's not included in the diagnostics saved in released configurations). However 2,290 TOTAL DOWNWARD PAR FLUX AT SURFA…
-
### Please describe your bug
Hello, the manual for Raspberry Pi (Remote Controlled Speakers)
under https://jellyfin.org/docs/general/clients/mopidy/#raspberry-pi-remote-controlled-speakers doesnt wo…
-
I have installed a fresh version of Allksy on an RPi 4 Model B Rev 1.1 (RPi 4 Model B Rev 1.1) running bullseye. Installation went smooth and ZWO ASI camera was detected up and running.
Now after a c…
-
Hello everyone,
I am planning a project using a Raspberry Pi 4B and the Lego Build HAT to control motors and sensors. However, I have read that without using the pwm function, communication with th…