-
I wanted to try using a Pico2 with a piCowbell DVI or a Pimoroni Pico DV base so I built a Pico2 firmware with picodvi enabled. I'm guessing that the Framebuffer_RP2350 routine has been updated to sup…
-
I saw that tape input is supported on the page. I would like to use a Pimoroni video out board, but I want to be able to use tapes. Will it read/write through the audio jack on the VGA/HDMI interface …
-
I found this when testing the Olimex port, but it occurs on other boards too.
Steps to reproduce:
1) Enter the menu, select a snapshot a load it
2) After the snapshot is running, press F1 to re-e…
-
Hi, is it possible to add support to this hardware?
-
Hi, I got the Pimoroni DV board thinking that I could drop the precompiled UF2 on and the emulator would be ready to go. But nothing happens, no video output, no LEDs flash, nothing.
Do I need to d…
-
Hi ,
Is it possible to use PicoW instead of a standard one? The Wi-fi options could be quite handy ;-D
Dont you think?
Thanks & regards for any feedback
-
Hi, Thank you for your great work,But I don't seem to find a way to support player2. Could you add support for player2 for two player games?
Such as two USB controllers or two original NES controll…
-
### CircuitPython version
```python
Adafruit CircuitPython 9.0.0-alpha.6-1-gfcfe2018bd on 2023-12-14; LILYGO T-DECK with ESP32S3
Adafruit CircuitPython 9.0.0-rc.0-dirty on 2024-03-08; M5 Stack Cardp…
-
Hello @fhoedemakers thanks for making this sick project.
I just got my Pico DV in and tried to boot this up but I just get a solid red screen out the HDMI.
I believe I've set up my SD correct and wh…
-
### CircuitPython version
```python
Any raspberry_pi_pico_dv_base firmware, including 8.2.3: adafruit-circuitpython-pimoroni_pico_dv_base-en_US-8.2.3.uf2
But also 8.1.0 and a few other (see below).
…