-
### Is there an existing issue for this problem?
- [X] I have searched the existing issues
### OrcaSlicer Version
2.2dev Nightly / 2.1.1 Stable
### Operating System (OS)
Linux
### OS Version
Ba…
-
My Pinecil V2 will not power on even though the power source I'm using meets the correct specs
**To Reproduce**
Pinecil gets plugged into usb-c1 port on the battery using pinecil usb c cable
**…
-
### The problem
Bluetooth proxy is setup in active mode and both irons have been freshly flashed to 2.22. HA discovered the irons instantly.
### What version of Home Assistant Core has the issue?
c…
-
### Affected Version
yay v11.2.0 - libalpm v13.0.1
### Describe the bug
Yay skips the final pacman "Proceed with installation?" prompt even when "--confirm" flag is set.
*This happens …
-
I have a Baseus charger and PD negotiation with Pinecil V2 sometimes works and sometimes doesn't and stays at 5V. I'd like to report it since the charger works perfectly with other hardware that I hav…
-
Entirely possible I botched the manual install (HACS doesn't seem to allow selecting an alternate branch.)
Here's what I get after autodiscovery runs:
```Logger: homeassistant.config_entries
Sour…
-
Trying to use v2 short 6 omh tips with pinecil v1.
1. Some 65W PD chargers are rebooting. It's pitty need to use another one.
2. Temperature is changing +-10 degrees while iron is working. It seems…
-
When trying to create a boot image I get an error that the Pinecil 2 is not supported. Here's the command and the error I get:
C:\Users\Me\Downloads\IronOS-Meta-main\Bootup Logos>python img2logo.py…
-
**Describe the bug**
When using IronOS companion, sometimes the tip temperature spikes up to 450C for one time point (see screenshot). I'm not sure whether this is an IronOS or a companion bug, the…
-
**Describe the bug**
I have a Chinese somewhat generic power supply that looks like an "updated PinePower Desktop": it has two USB-A and three USB-C. The last USB-C port supports PD3.1 140 W
With …