-
I am using fix access log build and rc522 reader and UID was scanned correctly, but every few hours rc522 would stop responding which can be fixed by restarting esp. So I tried using PN532 reader but …
-
Hi I really liked the project and i wonder if you can make a version of the same code that uses UART protocol to communicate with PN532 over groove port
Thanks
-
I’ve got a reader in a place with a wifi antenna, switching power supply and 230v wiring all nearby.
It was rock solid when I tried it for a week at my desk without these noisy neighbours.
But wit…
-
Bonjour, j'ai télécharger votre bibliothèque pour ajouter au logiciel Arduino et il indique qu'elle n'est pas valide
-
**Describe the problem you have/What new integration you would like**
I have a PN532 component and connected it with IIC to an ESP32 and used the [PN532 esphome component](https://esphome.io/comp…
-
I have a two I2C devices connected to an ESP32, the cable goes from the board, to a PN532 NFC reader, then to an LCD. The sketch first enumerates the devices on the bus, then brings up the LCD and t…
Kv603 updated
1 month ago
-
- Arduino board: Arduino Giga R1
- Arduino IDE version (found in Arduino -> About Arduino menu): 1.8.16 / 2.0.2
- List the steps to reproduce the problem below (if possible attach a sketch o…
-
I am using the SPI mode. When I run the following snippet code:
`interface = Pn532Spi(Pn532Spi.SS0_GPIO8)
pn532 = Pn532(interface)
pn532.begin()
`
the begin() method is raising the error "FileNot…
-
Are serial speeds other than 115200 supported when using pn532?
Both:
device.connstring = "pn532_uart:/dev/ttyUSB0:57600
and
device.connstring = "pn532_uart:/dev/ttyUSB0:460800
produce a code dum…
-
Hey, I'm currently working on a new project where I'd love to use tinygo together with an [pn532 module](https://www.nxp.com/docs/en/nxp/data-sheets/PN532_C1.pdf). I'd be happy to contribute a driver …