-
Currently polynomial fits work as follows
```python
x = [0, 1]
y = [0, 1]
fit = Polynomial.fit(x, y, deg=1)
print(f"Coefficients for 1-order fit on {x=}, {y=}:")
print(f"Raw: {fit.coef}")
pri…
-
### General Vehicle Model
---
1. Initialize all system-level models
2. Perform all vehicle-level calculations
- Pull tire forces
- Pull aero forces
3. Include ``` use_mode ``` variable to indica…
-
Apparently the mechanism data for all the demonstrated cases have been generated for 4th order polynomial fits, consistently with Cantera and Chemkin. While this is not a problem for Sutherland models…
-
First issue: Near misses
Using 'legendre' baseline model option fits nearly the same baseline as gbtidl, with most deviation at the edges of the baseline. The attached plot shows there is a differe…
-
The cooling curves currently stop at 300eV, which is not great as upstream temperatures can reach that for some devices:
![image](https://github.com/cydcowley/DLS-model/assets/62797494/6c609f7c-06e9-…
-
I was fitting some polynomials using [numpy.polyfit](http://docs.scipy.org/doc/numpy/reference/generated/numpy.polyfit.html) with `cov=True` to get the covariance of the fitted parameters.
I wanted t…
-
Need FITS spectrum analysis software, in browser, to replace SalsaJ. Likely in javascript/html5. Like https://js9.si.edu/, but for SALSA spectra. Should have similar functionality as Matlab SalsaSpect…
-
Occuring when the routine deals with the continuum analysis:
```
--OBS_DIR: /data/spirou4/apero-data/offline/red/23BQ01-Aug09
19:04:20.672-**|POLAR[11892]| --EXPOSURES[0]: [TELLU_OBJ] 2890757o…
-
- [x] clean up the create_dispersion solution code ... from bottom up
- [x] use the RMS predicted vs measured location deviation for the full MPH line-sets to remove poor MPH sets (prior to polynomial…
-
See Roy Axelson's request here: https://www.aavso.org/comment/162089#comment-162089