-
EDIT 2: Using the Aqualink Touch protocol `extended_device_id=0x31` works better - power / rpm goes to zero when the pump is turned off, shows higher power when priming, then the correct power / rpm a…
-
I'm using OpenHAB over MQTT to send commands and read status from AqualinkD. Overall, I have to say the service is amazing, and incredibly adaptive and configurable to all of the various hardware conf…
-
Hello. Despite reading through the wiki and forums I am still struggling to get this miner to run properly. I’m trying to set this miner up in stealth mode. Mining ETH on 2minerspool. I have this poo…
-
Hi, @sfeakes ,
Before describing my issue, I want to thank you for what has to have been an incredible amount of time spent on this project. And congrats on an awesome project.
I'm having some …
-
Hi, I am just starting with AqualinkD. I believe it installed correctly as it allows me to start and stop the daemon. If I try and use the serial logger I get:
./release/serial_logger: /lib/arm-li…
-
I have `convert_mqtt_temp_to_c=true` but the temps in the dashboard are what I would expect
However in mqtt is showing -17
aqualinkd.conf
```
# aqualinkd.conf
#
# The dir…
-
This is similar to a recently closed issue #85 regarding SWG's bouncing between X% -> 0 -> X%. I have been having this issue since updating to 1.3.6 although I am not convinced this version is defin…
-
AS the subject says. I am getting the correct display in the we interface 27C but via MQTT I am getting -2.78 I can't see any seetiing that may be effecting this.
```
# aqualinkd.conf
#
# …
-
I know that you have had VSP support listed as a to-do for a future version. Any idea when this will be available? It's the only component of my pool that cannot be controlled by Aqualinkd and once …
-
20:35:09.732 Debug: PDA Menu Line 0 =
20:35:09.735 Debug: PDA Menu Line 1 =
20:35:09.735 Debug: PDA Menu Line 2 =
20:35:09.735 Debug: PDA Menu Line 3 =
20:35:09.737 Debug: PDA Menu Line…