-
![PXL_20240829_210346509.jpg](https://github.com/user-attachments/assets/b5ad28d7-4ef6-4b44-b91c-0bde42ff4fb6)
Default, IoLT setup instructions - except in streaming mode, similar to the magnetometer…
-
### The problem
The number platform is missing as described [here](https://github.com/home-assistant/core/pull/127406).
In addition, the following sensor entities are also missing in my Home Ass…
-
This ticket is to integrate the brake pressure sensor into the development/ evaluation kit of the dashboard.
-
Arduino board: Arduino Nano v3
Arduino IDE version (found in Arduino -> About Arduino menu): 2.3.2
Dear Maintainers!
I would like to ask for some improvement of this library to make it more rob…
-
Anyway to setup a 4-20mA pressure sensor with the SM IND board input. I can acquire the signal, but can only use voltage when setting up a generic device for filter pressure. Also using 4-20mA for P…
-
The Argo data system has no present method to report a pressure sensor that reports absolute pressure. PRES is sea_water_pressure (e.g. 0 at the surface). I'm requesting modification of the NVS tabl…
-
### Sensor Description
TDWLB-LC-RPPF remote pool pressure monitor
### Additional information
[CirrusSense Wireless Pool Filter Pressure Gauge](https://transducersdirect.com/wireless-pool-filter-pre…
-
Pozdrav vec nekoliko dana pokusavam da ozivim klimerka..
dakle..koristim NDU ESP8266 (CP2102 cip) , senzore koji su neophodni i konstantno dobijam isti odgovor a to je
[PMS] Air Quality Sensor (P…
-
This is a very important sensor value, when growing plants.
WPD of the leaves tell you about the resperation of the plant.
VPD = VPleaf - VPair
VPleaf = 610.7 * 107.5*Tleaf/(237.3+Tleaf) / 100…
-
I am attempting to install the BDSensor on top of my mainline Klipper install. https://github.com/markniu/Bed_Distance_sensor/wiki/Installing-for-Klipper
If I add the required BDSensor section in m…