-
Hallo Cooles Projekt,
ich habe eine Intex pureSpa Model SB-H20 (von 2020), bei dem wird das Display ausgeklappt und hat keine Teleskop-Funktion?
Ich weiß nicht genau wie weit das mit den Modellen…
-
Hi! Congratulations on the project! I am bringing to life my intex spa, just like yours.
Would it be possible to have some short directions on how to upload\load everything in the pico?
Also, t…
-
Hey Richard,
Great project you have started here. I'm also looking to do something similar to my Intex spa. Final product would ideally be able to control the spa remotely maybe using ifttt or some…
-
have tried to compile aover arduino IDE 1.8 and platform IO
on PIO i bacome an error Tasmota 8266 not avaible
so ich change the platformio.ini
[env:d1_mini]
board = d1_mini
board_build.f_cpu…
-
Hello Byron,
first up thanks for your project, I am so looking forward to being able to remotely control my „dumb“ spa!!
Currently I am stuck in the soldering phase and cannot get the Pico to po…
-
Hi,
Thanks for this amazing apps.
I realise that current temperature is not updating automaticaly. To check it, I have to modify the desired temp and then current temp is changing.
How can I d…
-
### Analysis
Any update shows: GET https://registry.npmjs.org/homebridge-config-ui-x error (ERR_INVALID_THIS). Will retry in 10 seconds. 2 retries left. I couldn't update anything in homebridge, also…
-
To simplify soldering PCB, is it possible to use a board level shifter and the capacitor?
The guy here: https://github.com/RealByron/PicoW-Intex-PureSpa only uses capacitor and commercial level shif…
-
Dees anyone work in this version (after update to 2023.08)? Before update was fine.
My SPA is PureSpa Greywood Deluxe v22111, firmware 1.0.300. Intex aplication is working, spa is online.
Edit
My m…
-
Dear Sir,
Thanks for sharing your project. It is very interesting.
I expose my issue:
My solar inverter closes a relay when reaching some photovoltaic sun irradiance parameters.
I want to t…