-
### Is there an existing issue for this?
- [X] I have searched the existing issues
### Problem description
Doing a pad operation from an external file is changing the active view to go to the…
-
### Is there an existing issue for this?
- [X] I have searched the existing issues
### Problem description
I was going to do the Basic Techdraw Tutorial, but when I loaded the Basic_Part_Design_Tut…
-
### Is there an existing issue for this?
- [X] I have searched the existing issues
### Problem description
…
-
### Is there an existing issue for this?
- [X] I have searched the existing issues
### Problem description
I don't work with part design very often, but even rare attempts have revealed the inconve…
-
### Is there an existing issue for this?
- [X] I have searched the existing issues
### Problem description
The latest change of my design using the latest Appimage (`1.1.0dev.39057`) started to giv…
-
### Is there an existing issue for this?
- [X] I have searched the existing issues
### Problem description
I've noticed that when I'm working on several iterations of a design, and have them saved …
-
### Is there an existing issue for this?
- [X] I have searched the existing issues
### Problem description
The picture shows two objects. Circles on B-spline path.
The left one is obtained u…
-
### Is there an existing issue for this?
- [X] I have searched the existing issues
### Problem description
When using Arch Slot on Part Design WB, I cannot constraint both ends.
This is the not…
-
### Is there an existing issue for this?
- [X] I have searched the existing issues
### Problem description
If we created an object with the sweep tool - we cannot turn it into a through pipe …
-
### Is there an existing issue for this?
- [X] I have searched the existing issues
### Problem description
Steps to reproduce:
- Open new file
- Start Arch_Wall command
- Close the file by cli…