-
Hello,
Downloaded the boat loader and compiled the sketch but unable to upload the sketch
the download step is done via usb com port from arduino or using a programmer? and is the battery necessary…
-
Based on https://community.platformio.org/t/platformio-microchip-samr34-lora/10789/12.
The store https://electroniccats.com/store/ sells a few Atmel SAMD/E/R/C based development boards, for exampl…
-
I was looking at the part where you bridged the 16-pin pad so that the 6-pin RS232 pad gave you Rx/Tx (nice!). However, which USART are they connected to? USART0 or 1? I would suspect USART0 but would…
-
Sleep modes with the Arduino IDE
Examples
https://github.com/RAKWireless/RAK4260_Low_Power_demo
-
I was trying to have a Lora sender and receiver code with RAK4260. With few tweaks on Sandeeps Lora library, got it working, here is the updated sktech:
#include
#include
int counter = 0;
voi…
-
Hello!
I'm using yours OTAA examples on RAK4260 (SAMR34J18 + SX1276) /w BastWAN bootloader - EU868 Band.
Everything works ok until I stay in Class A. (both Uplink+Downlink+ACK... etc.)
When I swi…
-
I've been working with a RAKwireless RAK4260-Dev board and was not getting the RSSI values at my gateway that I was expecting to see. Finally tried adding this to my sketch:
lora.setTxPower(14,RFO_P…
-
I've been working at using this to program a Rak4260-dev board using the bastwan as selected board in the Arduino IDE.
As far as I can tell the pins 32 and 33 on the RAK4260 must be hardwired to the …
-
Hello there!
I'm also trying to resolve this issue on [the TTN forum](https://www.thethingsnetwork.org/forum/t/sam-r34-lorawan/42447) but here I'm just looking at the BastWAN core aspect.
I rece…
-
HI,
Where can i find setup for SX1276 chip example because we have only for RFM95W chip ?
Thank
Eric