-
Seems that the link to buy the board is no longer correct:
https://www.pcbs.io/share/rwjd1
That points to an expired domain pointer, how can I purchase the board ?
-
Hi,
use Ubuntu 16.04
make[4]: Entering directory '/mnt/f/rak831-openwrt/wiswrt/15.05-rak-rc2/tools/automake'
(cd /mnt/f/rak831-openwrt/wiswrt/15.05-rak-rc2/build_dir/host/automake-1.15; AUTOM4TE=…
-
First of all, thanks for this library. I used it to get a number of boards talking to one another including the Adafruit 32u4, HELTEC esp32 based boards and even an STM32LRWAN1. They all work great.
…
-
Hi there,
I have LoRa gateway (RAK831) which has sx1301 chip for LoRa connectivity. My nodes are based on sx1278 chip. Frequency band is 433Mhz. In selecting the target radio transceiver sx1301 is no…
-
Hello! Thank you very much for this guide.
I have followed your instructions but this error has been thrown at me:
**ERROR: Version of calibration firmware not expected, current: 255 expected: 2**…
Eitol updated
6 years ago
-
Thanks for the awesome setup procedure. I've successfully used it with a RAK831 board and RAK's official shield (converter board) for the Raspberry Pi 3. However the GPS module soldered onto the shiel…
-
Hi,
Thank you so much for the script. Executing `./lora_gateway_pi2` worked very well using Raspberry Pi 3B+ and LoRa GPS Hat as gateway. However, the gateway I used was single channel gateway. Now…
-
After installing on RAK831 Pilot Gateway and configuring via gateway-config I noticed there was no way to configure the sub band as is possible with LoRaServer-OS direct from Orne Brocaar.
To get t…
-
Hello Sir,
I have run your code on my SX1301, unfortunately, it gives output unrecognized transceiver, when I run the number 1 on the list.
I am aware that your code is for SX1272/SX1276 but I …
-
This issue is for collecting information about LoRaWAN and implementations from [Congduc Pham's Gateway](https://github.com/CongducPham/LowCostLoRaGw/tree/master/gw_full_latest).
# Single-Channel …