-
Initial discussion on Elixir Forum: https://elixirforum.com/t/missing-console-on-raspi3-7-touchscreen/66393
### Environment
* Elixir version (`elixir -v`):
```
Erlang/OTP 27 [erts-15.1.1] [sou…
-
Hi,
I've got an issue running the has-mqtt-publisher container (from repo) on Raspi3 (armv7l). It starts properly but doesn't deliver all values:
[2024-03-15T15:12:55Z INFO hms_mqtt_publish] Ru…
-
qemu-system-aarch64 -M raspi3 -append "rw earlyprintk loglevel=8 console=ttyAMA0,115200 dwc_otg.lpm_enable=0 root=/dev/mmcblk0p2 rootdelay=1" -dtb dtbs/bcm2710-rpi-3-b-plus.dtb -sd 2020-02-13-raspbian…
-
Hi Jason,
hope you're doing well.
Thanks for this addon. Its been super helpful.
Although I am not able to record.
The recording example would throw a segfault when trying to record.
nothing that…
-
### The problem
I'm having the same issue. Restored a backup from an old installation on a Raspi 3B onto a Raspi 5. Now rebooting from the web ui will not work until I power-cycle the pi.
### What v…
-
Just looked more detailed into Debian binary packages and saw that the following
checks about spelling errors are part of the Debian raspi3-firmware package:
https://sources.debian.org/src/raspi3-…
-
When I connect the ribbon cable to the Rasperry Pi 3 it shuts off. Just having the multiplexer connected to the GPIO headers doesnt cause it to fail. Only when I connect the ribbon cable from the Inpu…
-
### Preliminary Docs
I confirm that I have read the [CONTRIBUTING](https://github.com/ccrisan/motioneyeos/blob/master/.github/CONTRIBUTING.md) guide before opening this issue.
I confirm that I h…
-
I would like to use this to get data from RF receiver to MQTT (mosquitto). The receiver will receive data from motion sensors. thermometers, humidity meters etc. Is it possible to use this script?
-
@ralphm2004
After starting broadlink-thermostat.py as a service the variable loop_mode of a device has not the value of the config option loop_mode of broadlink-thermostat.conf.
broadlink-therm…