-
Hello! I was wondering if this was possible as I have 10 of these chips laying around in my workbench
-
### Is your feature request related to a problem? Please describe.
So i am designing a control board based on the stm32 blackpill and because of a limited number of pins, i've had an idea. I'm trying…
-
Hi Juani13973! I want to build my version on Pedalino and I want to ask you a question. How did you managed to connect 18 footswitches? Did you use resistor ladder? I want to connect 8 footswitches, w…
-
My Genie CM7600IC works well in dry contact control mode for door control and status (the obstruction sensors are too high voltage and aren't connected). However, the Genie wall control keypads have l…
-
The filter overlays the filtered signal with a nasty 1kHz signal. The SPI dacs update with 1kHz update rate. Changing this changes the hum.
Since SPICLK is running at 5MHz, and since touching the S…
-
can we use arduino with sink and source options
for input and output as normally arduino interface in market use sink (low level trigger) option
-
**Attached version of Reminder_Analog has the following improvements:**
- Uses new version 2.0 of Sujay Phadke's HTTPSRedirect
https://github.com/electronicsguy/ESP8266/tree/master/HTTPSRedirect…
-
Hello!
I am a fan of 8-bit microcomputers and an electronics hobbyist. I have built for my own use a cable for Commodore 128 that allows to view images from C128 on TV screen in 80 column mode and …
-
Hi ,
I am using your code to interface ATM90-E26 with ESP8266. Ran the default code without any calibration and got this output, the output should be around 230V but I am getting 0.03V. The circuit…
-
This would allow even more crazy ideas.