-
*enyc:*
Probably, FAO "John Crispin" Lantiq maintainer, apparently!,
On OpenWRT 19.07.0rc2, both on TP-LINK TD-W8980 and also BT-Homehub-v5-type-A [lantiq xrx200 devices] ...
I am findin…
-
### Describe the bug
The MTU set in `/etc/config/network` for `interface 'wan'` is not respected when the interface is (re)started.
Full config for `wan`:
```
config interface 'wan'
o…
-
Well, subject line does it :)
Would be very handy to setup PPPoE connections in same concise manner as I do with other interfaces, get them exposed to networkctl, track dependencies on underlying eth …
-
**Describe the bug**
BNG Blaster supports to change the PPP MRU to a higher value than 1492. According to RFC4638, the client has to send the PPP-Max-Payload-Tag in PADR to notify the peer that a h…
-
while configuring AdGuard Home DNS server to use on router, by adding ipv4 address works fine with 192.168.x.x only. if enabled with ipv6 on router by adding AdGuard Home DNS server ipv6 address, the…
-
*nicefile:*
Dir878 /882 /882-r1 (mt7530)
OpenWrt SNAPSHOT, r18502-53b87a7a28 but seems linux 5.10 builds are afected as 5.4 kernel it's fine.
There is issue with setting MTU to 1508 for DSA dr…
-
The UDM by default sets ppp0 with MTU 1492, eth4 with MTU 1500 and eth4.6 MTU 1500
To avoid broken VPN tunnels and other issues, it's desired to set:
eth4 mtu 1512
eth4.6 mtu 1508
ppp0 mtu 1500
…
-
WG Last Call: draft-ietf-netmod-intf-ext-yang-07, Qin reviiew issue 4)
I am not sure L2 MTU is common attribute applicable to all packet frame based interface, in most case, we are using L3 MTU.
>…
-
Setting the WAN PPPOE mtu to 1500 and setting link parameter of associated vlan to mtu1508 does not correctly set mtu for parent device to 1528 and thus doesnt allow raising of vlanmtu to 1508.
Thi…
-
*dwmw2:*
I have a TP-Link TDW8970, used with VDSL.
It seems to limit me to a PPP MTU of 1492. I need to increase the MTU on the ptm0 device to 1508 AIUI but it won't let me. Could it be as simple …