-
Robo - been trying to get Jack Kelly's version compiled, but problems under IDE 1.0.1, Windows 8.
Same issue with yours:
Rfm12b.cpp.o: In function `Rfm12b::interrupt_handler()':
C:\Users\Andy\AppData…
-
I followed the instructions including rpi-source.
Make fails early when it compiles rfm12b.c. Details below.
Any idea??
```
$ make
make -C /lib/modules/4.19.118+/build M=/opt/public/rfm69/rfm1…
-
Hi
I,m try to do this
cat /dev/rfm12b.0.1
and i see received data, but i try open device with python open and not see anything
maybe you know how to work with device in python?
-
Hello !
I'm trying to lauch rfm12b kernel module on OSMC OS. I've sucessfully downloaded kernel headers and sources (kernel version 4.4.8-3-osmc). I run sudo make command and .ko file was generated s…
-
Hello,
I try to recompile on raspi
Linux raspberrypi 4.1.13-v7+ #826 SMP PREEMPT Fri Nov 13 20:19:03 GMT 2015 armv7l GNU/Linux
I followed the process:
git clone --depth=1 git://github.com/raspberry…
-
```
What steps will reproduce the problem?
tidy up code
What is the expected output? What do you see instead?
"lcd3110.c" --> "lcd3310.c" + "protocol.c"
Improved code maintainability
```
Original …
-
```
What steps will reproduce the problem?
tidy up code
What is the expected output? What do you see instead?
"lcd3110.c" --> "lcd3310.c" + "protocol.c"
Improved code maintainability
```
Original …
-
Trying to get the code running on an RFM12B RFM2PI module, however it gets as far as this on initialisation and then makes no further progress
EDF IAM Receiver
SPI initialised
Attaching interrupt
-
Hi @aShure
The Tontec 2.3 inch LCD uses the pins 1 to 26 of the Pi B+ 40 pin GPIO. It uses SPI (http://www.itontec.com/download/). I'm downloading their huge documentation file to see if I can gathe…
-
Hi.
In the attached rfm12b.c file I did changes in the 2 timer_callbacks to compile with new kernel.
might you will update the code ? the module runs on a pi-ZERO , I testet only receiving without A…