-
I'm using your sketch on an RFM12PI module connected to a Raspberry Pi. I've got a SWALEC branded CurrentCost unit.
Roughly every 3 seconds, I see a pairing request from id 4095. I never see a power …
-
Hi @aShure
The Tontec 2.3 inch LCD uses the pins 1 to 26 of the Pi B+ 40 pin GPIO. It uses SPI (http://www.itontec.com/download/). I'm downloading their huge documentation file to see if I can gathe…
-
I just upgraded to Buster and in the process I also upgraded emoncms and emonhub. It appears that emonhub is not receiving data. I can see the light on the radio receiver blink about every 10 seconds…
-
The next big thing is to build some open hardware sensors for pimatic.
The Quest is to build a hardware 433mhz sender based on arduino or a ATtiny AVRs that collects environment data like light inte…
-
@Jerome-github / @pb66 - you should be able to try installing `emoncms-hub` from the apt repo and it should run through basic configuration questions and get up and running...
I had to make a couple …
-
(Rough draft 9th September 2014 - to be improved)
## Summary of recent development
Emoncms development in the first half of 2014 focused on improving the data core of emoncms, how timeseries data is …
-
Upgrading from V7 to V8 via git stops rfm12pi from loading. Reinstalling rfm12pi does not solve issue.
-
I noticed that Open Energy Monitor binding uses additional C script to read serial and that forwards data to UDP port which is then read with Java. Why not to read Serial directly with Java? @pauliant…
-
Downloaded https://github.com/LowPowerLab/WirelessProgramming
But it looks like its made for a moteino gateway rather than an onboard RFM12Pi. I'll try to use avrdude with [this patch](http://harizan…
-
Hi all.
There has been talk already about lowering the bitrate to improve the communication range. I did it myself and I would like to share a few thoughts, with the hope that we could make that easi…