-
./rigsync -m 2 -r localhost:4532 -m 1027 -r /dev/ttyUSB0
*** Could not open rig 2: rig_settings_get_path: path=/home/pi/.config/hamlib_settings
rig_settings_load_all: settings_file (/home/pi/.config…
-
Добавьте в настройках TCI возможноcть выбора сразу двух Transceivers. Сейчас там Transceiver1 и Transceiver 2. А нужно BOTH.
Это нужно для работы с транзисторным усилителем в режиме SO2R. Посмотрите…
UA6AA updated
10 months ago
-
Hi, I was using this tool a year or so ago, and had it working really well. New system, recompiled, etc, and for some reason, while it eventually does sync the two rigs, it can take up to a minute or …
-
I was looking for something that I could setup to track my Kenwood890s and my SDR frequency. I THINK this is what I am looking for, I was able to make it on MacOS and run it. However, I think I must …
-
There are issues with Hamlib 4.4 (possibly earlier versions, as well) that prevent rigsync from working correctly when built with it.
If you need Hamlib 4.x to support newer rigs, it is recommended…
-
I see that you have a rigctl server which is great, and I might be able to utilize this to do what I'd like. However a rigctl client module would be even better.
What I'd like to be able to do is h…
-
For third party software perhaps provide a line in for soundcards/VAC
Something like my image below perhaps?
![Line in suggestion](https://user-images.githubusercontent.com/101397850/178296266…
G4POP updated
11 months ago
-
Tx Audio cuts out randomly while using vox. I've played with the vox setting and the noise-gate settings with out solving. It happens on my two dell I7 computer with Windows 10. While talking along, …
K6TWO updated
10 months ago
-
Rigsync lost Soundcard TX and RX gain setting when restart.
W10, EESDR3 1.0.1 beta
OK2WY updated
2 years ago
-
Something isn't right with Audio in the new RigSync application.
What I found is this, sure use RigSync for CAT interface to TCI- But using my old method of making VAC work in V3 that is setup one…