-
### What is the issue?
Hello everyone, I am trying to use Tailscale to connect to some peers in direct connection, but unfortunately, the connection is being intermittently relayed through a DERP ser…
-
**Describe the problem you have/What new integration you would like**
I would like to use the slimmelezer in Austria with the Sagecom T210-D-r and the Sagecom S210 energy meter.
All informatio…
-
I happen to have a Sagecom F@ST 3686v2, and its GatewaySettings.bin is perfectly read by bcm2-utils, except for the firewall sections:
```
C:\Users\agust\Desktop\bcm2utils-v0.9.4-win32>bcm2cfg.exe…
-
Smartmeter sendet zwar, was ich aber bekomme wenn ich serialtest ausführe, "wrong DLMS tag". Was kann ich tun?
-
**Describe the problem you have/What new integration you would like**
Is there a possiblity to integrate a sensor for a p1 dsmr watermeter.
**Please describe your use case for this integratio…
-
Ich habe leider bei einem Netz NÖ Kaifa Zähler ein Problem.
1) Scheint das Timing hier etwas langsamer zu sein, die Pause zwischen erstem und zweitem Datensatz sind ca. 160ms:
![grafik](https://…
-
Hi,
I have a problem described below. Is there any solution?
#### Platform
- Hardware: ESP8266-12F
- Core Version: Any higher then 2.5.2
- Development Env: Arduino IDE
- Operating Syst…
-
Hi Matthijs,
I have seen reports that belgium smartmeters do not parse correctly using the 5.0.2 dsmr parsing. This is due to the extention made by the Belgium netbeheerder.
The document for Belg…
-
## Versions
| Key | Value |
|-----------------------------------|-------|
| Home Assistant version | Core: 2024.1.2 | Supervisor: 2023.12.0 | Operating …
-
Hello,
I have a Sagecom Router which is provided by KPN (Netherlands).
I am not sure which Route Model it is and the device info is also not very helpful to me.
Maybe anybody her can give me advice…