-
### Issue
When using sht41 sensor in "normal" or "low-power" mode everything is working fine. However when I set single-shot mode, CO2 reading values are incorrect:
- for measure-mode = "single-sh…
-
Подробное описание есть на сайте контроллера.
https://ab-log.ru/smart-house/ethernet/MegaD-2561-SCD4x
Спасибо.
-
As a Rasp Pi & Grove noob, I'm having trouble getting this project to run without errors. I do have coding experience though not much in Python. Could you provide some advice on this error please?
L…
-
**Describe the problem you have/What new integration you would like**
SCDx sensors have three operating modes that affect, above all, your consumption.
- **Periodic measurement mode** updated …
-
### Version
_No response_
### Describe the bug
Hello, first of all thank you for providing a really good library.
I notice a small bug on scd4x_read function in which would use temperature_raw i…
-
Hello,
Trying to read SCD41 using Sensirion I2C SCD4x library, but compilations give below error:
.
.
.
C:\Users\DELL\Documents\Arduino\libraries\Sensirion_I2C_SCD4x\src/SensirionI2CScd4x.h:399…
-
### The issue
I have tried to connect my SCD41 and I uploaded the [example](https://github.com/UncleRus/esp-idf-lib/blob/master/examples/scd4x/default/main/main.c) code to my [ESP32-C3-DevKitM-1](htt…
-
### The problem
The sensor will occasionally become unresponsive and send the message "Data not ready yet". Power cycling the device has no effect.
### Which version of ESPHome has the issue?
2021.…
-
I'm running this code on an adafruit esp32s2 reverse tft feather, with the scd4x connected (plus an SEN5x but it will gracefully accept not having one (hopefully). Code needs an adafruit io username +…
-
In low power mode, the reported temperature was about 2 degrees too low.
I tried setting `temperature_offset` to `2`, but it was still too low by ~.5 degrees, so I set it to `2.5`. As a consequence…