-
Finally I got my Testdevice running with a SGP41 sensor.
But I am curious about the computed values. What does a calculated NOx value mean? Is there any documentation about the output value and the…
-
Could this sensor added to the list of supported sensors
https://www.mouser.co.uk/ProductDetail/Sensirion/SGP41-D-R4?qs=A6eO%252BMLsxmRqwfOE5NYPVA%3D%3D
Data Sheet https://www.mouser.co.uk/dat…
-
At power on, the display says:
```
Sensor init
Error:
SHT not found
```
The sensor works fine in my older board. I don't know when this regression was introduced.
Debug log
```
ESP-ROM…
-
## Overview
- We encourage you to share your thoughts with us by leaving comments below.
- Whether you have a "solution-based" prototype, a deployable resolution, or just an interesting project idea,…
-
I have been using SGP41 sensors in combination with SHT41 for two or three years now. It works really well with a raspberry pi zero 2 with the algorithm provided by Sensirion. However, the self-heatin…
-
Hello. I've applied your 4.0.7 release to my Airgradient DIY PRO v4.2 board with all components.
When I using airgradient's software every sensor data was visible but 4.0.7 isn't.
Only what I did i…
-
I've been wanting to expand my knowledge of Github Actions and workflows/pipelines.
I see there is an existing Action that does some separate steps to install the arduino-cli and install libraries …
-
Does this button still exists? I don't see it on the home assistant overview. Below is my config
Switch to enable or disable SenseAir S8 CO2 sensor Automatic Baseline Calibration (ABC)
```
`da…
-
Hi, I have tried to evaluate the SGP41 on a desktop PC with ubuntu 22.04.4
I have installed a virtual environment and tried:
pip install sensiron-gas-algorithm
The Error I got then was:
ER…
-
Hi. For polling we use two bytes for the address/command and six for the humidity/temperature/crc input. Is it also possible to work with only a 16-bit address/command, so I could use DMA readout to a…