-
When configuring a yaml with other platform sensors, I can hover over the name and get a popup.
When I have sgp4x defined, hovering does not display any helpful information
```yaml
- platform…
-
Hi,
Since the update my AG Pro (sht30) keeps resetting every ~2 minutes with the ESPHome logs being:
```
...
[23:12:17][D][pmsx003:234]: Got PM1.0 Concentration: 8 µg/m^3, PM2.5 Concentration …
-
Hello. I've applied your 4.0.7 release to my Airgradient DIY PRO v4.2 board with all components.
When I using airgradient's software every sensor data was visible but 4.0.7 isn't.
Only what I did i…
-
The console is logging the measurements however, the OLED display isn't working.
I have this version of the [Airgradient Open Air.](https://www.airgradient.com/shop/#!/AirGradient-ONE-Indoor-Monit…
-
### The problem
If i flash the firmware i can see it (the board not work with BME680):
```
[11:01:29][E][safe_mode:086]: Boot loop detected. Proceeding to safe mode
[11:01:29][E][component:164]: C…
-
## Do not report new issues related to this message, instead please comment on this issue with the logs that you see and the config for that component.
### The problem
```
[00:00:00][W][compone…
-
### PROBLEM DESCRIPTION
_A clear and concise description of what the problem is._
The value send to Domoticz via the Domoticz config / idx AirQuality is the SGP40 Raw sensor value. Domoticz can'…
-
**For the AQI**
This will help with some compatibility with other sensors from other integrations (right now my workaround is to add a customize: section to my configuration.yaml file).
Also, if pos…
ncd7 updated
3 months ago
-
The AirGradient DIY Air Quality Sensor (Pro Version PCB Version < 3.7) ceased showing voc or tvoc with SGP41 sensor
-
Hi MallocArray,
I'm experiencing an issue where the reported CO2 sensor goes from 350 ppm, to 65555 ppm, and then it continues to count down from the latter value until the measured CO2 value again…