-
I feel like an idiot for asking this here, could not find a conclusive answer anywhere. Is it possible to run OpenOnload on non solarflare / Xilinx hardware. Aka if a setup my hosting from AWS, is it …
-
While doing connections with standard non-TCPDirect sockets, it's quite simple to load the CA certificate and exchange data with SSL_read and SSL_write using the module in C++. On trying to do someth…
-
👋 This dashboard summarizes my activity on the repository, including available improvement opportunities.
## Recommendations
_Last analysis: Nov 08 | Next scheduled analysis: Nov 15_
**NOTE**: I'v…
-
We experienced a network card port disconnection on a server equipped with a Solarflare low-latency network card at around 07:41 this morning. Attached are the relevant logs. Please help analyze the c…
-
Maybe this is more of a how-to question rather than an issue, but it's unclear from the documentation how i can go about achieving this. I basically want to listen to multiple mcast groups on the same…
-
I'm benchmarking two machines with SFC9250 cards direct connected with 25G fiber on one port, as well as via a 10G switch on the other port. If the ctpio threshold is larger than the packet size, the…
-
Hi,
I would like to be able to publish on a multicast address such that processes both on the local machine and on remote machines are able to receive these messages.
I am using Solarflare cards…
-
I tried running nc using onload in server configuration but it does not wait for connections and immediately closes.
**command:**
` sudo onload nc -l 12345`
**output:**
```
oo:nc.openbsd[1303]: U…
-
# Issue description
Using onload prior to running a binary which uses epgm protocol to create a ZMQ_PUB socket results in an assert failure despite zmq_bind returning 0 (no error). I suspect that onl…
-
Scenario:
- Bonded interface on Linux, member A) is vendor X (say Solarflare) for which libcck loads vendor extensions
- Bonded interface member B) is vendor Y, for which libcck also loads vendor e…