-
**The problem you're addressing (if any)**
Some platforms do not flash well with flashrom programmer linux_spi. Somtimes even flashrom dediprog programmer has problems with properly flashing the devi…
-
There is a lot of information out there on ch341a programmer giving too much voltage (5v vs 3.3v). Users reports of having bricked their laptops (SPI chip to motherboards resistors).
One of those e…
-
Hi,
After flashing ZigbeeTLc into modified ZTH02 using TLSR825xComFlasher, FW did not start. I did verification readout and found out, every first write after sector erase will not succeed. This is n…
-
Previous related posts: #1 and #3.
As I mentioned in the last post I got some LEDs blinking. Before I present the findings, I should first outline some parts on the MCU board:
- Ethernet switch:…
-
Hi DediProg team,
I recently received a new SF100 programmer and try to connect to my Linux computer, was able to built the software tool but got an issue to connect it.
```
$ ./dpcmd --list
DpC…
-
Add support for flashing the Spansion S25FL512Sxxxxxx1x and S25FL512Sxxxxxx1x(Secure)
https://www.alldatasheet.com/datasheet-pdf/pdf/598698/SPANSION/S25FL512S.html
-
Hi
i'm new here but for a heating control project i was told that the hr20 supports serial commands so i thought that would be great since i want to make a combined roller blind control and heating…
-
I have wrote an article that describes a method of internal flashing that was not fully described for disabling ME before, considering it would ideally fit as a new flashing method for me_cleaner wiki…
-
As long as the linuxspi or linuxgpio programmers were enabled at compile time, there shouldn't be a need for patching avrdude with a separate programmer for alamode. Arduino IDE (not through Raspbian)…
-
How do you flash the firmware to the malenki nano?