-
At least with my setup exposing the ports for using one external srsenb setup with physical phones **and** internal srsenb_zmq for srsue does not work, because then the srsenb_zmq container can't conn…
-
## Issue Description ##
The issue only appears when using the N310 in a two channel configuration. It happens occasionally but is annoying nonetheless since its causing many tests to fail because t…
-
When I ran srsenb, I encountered the following warning and the srsenb cannot start.
[WARNING] [MULTI_USRP] Could not set RX rate to 11.520 MHz. Actual rate is 11.703 MHz
[WARNING] [0/DDC#0] The re…
-
![POZA](https://github.com/srsran/srsRAN_4G/assets/125991526/67390dc7-7039-4ac6-9a16-e3d79b20085d)
## Issue Description ##
I am encountering a persistent issue while attempting to run srsenb with a …
-
Hi @herlesupreeth,
I have failed voice calls on my platform:
"4G Volte deployement with B210:
docker compose -f 4g-volte-deploy.yaml up
docker compose -f srsenb.yaml up -d && docker container at…
-
I am trying to implement the zynq_timestamping solution by porting the existing implementation into ZC702/ZC706 + FMCOMMS5.
Having as reference the Block design of the ZCU102 and AntSDR, I managed to…
-
Hi all,
I successfully connected srsenb with nextepc in the same computer, by modifying mme_addr and s1c_bind_addr in enb.conf of srsenb to the network address of my computer.
However, when I wa…
-
BRANCH: add_probes
MAKE ends with
[ 92%] Built target srsenb_rrc
[ 92%] Built target srsenb_s1ap
[ 92%] Built target srsgnb_ngap
[ 92%] Built target srsgnb_upper
[ 93%] Linking CXX executable …
-
Hello, I followed everything you did in the blog post however apon launching srsENB it initialises the device and puts out a single spike on the transmitted frequency and spams the console.
I'm ru…
-
Hi @herlesupreeth , thanks for making this docker and tutorial for programming the SIM card!
I'm trying to make a VoLTE call with the dockerized setting, but I'm facing some troubles now.
Below …