-
### What happened
I have hybrid hardware, and it was initially enabled, but due to doing some debugging I set it to CoreXY mode.
Rather than changing my wiring, instead when I changed to corexy, I…
-
### Did you test the latest `bugfix-2.1.x` code?
Yes, and the problem still exists.
### Bug Description
Hello,
I have an ortur 3d printer with an upgrade skr 1.3 motherboard.
Z uses dri…
-
all the documentation and examples only point to being able to set the Microsteps if you have hardware serial. Unfortunately my setup does not allow for using another but an arduino nano that doesn't…
-
Hi @MicroBahner,
Since many stepper motor drivers must be controlled by Open Drain output, it would be great to support this. Currently, I achieved this by changing some lines in the "src\utilities…
-
Hi friends,
Is it posible to use DRV8825 stepper driver with gobot?
Thank you, very much.
-
What does the pins on the driver do? Check these:
* GND
* +5V (Does it provide or need 5V here?)
* DIR (Most likely: 5V HIGH/LOW sets direction)
* STEP (Most likely: short 5V HIGH pulses increme…
-
Good moring to all,
I am found of BIGTREE product, and during the process of upgrade a Ortur 4 printer with following components I have a printing issue with my new S42C driver.
on each layer, y…
-
I'm not quite sure the problem, it may be due to current/voltage, or the wiring of the `stepper -> TMC2209`. The wiring should be the same as [this schematic](https://github.com/quintindunn/StringArtR…
-
Trident 300 cubed LDO Rev A Kit.
After enabling klipper_tmc_autotune for the motors I have, if I'm printing multiple objects, the very first object's first layer looks normal. When it moves to the…
-
[Chameleon Macros.txt](https://github.com/user-attachments/files/17088959/Chameleon.Macros.txt)
I have a modified 3D Chameleon filament changer system using directly connected stepper drivers to …