-
### Description
Please add a `.repl` file for STM32 G4 processors.
### Usage example
`machine LoadPlatformDescription @platforms/cpus/stm32g4.repl`
### Additional information
The exact …
-
The STM32G4 FDCAN clock mutliplexer is not being set. It is using the default value of 0 and therefore using HSE clock.
Adding RCC_CCIPR |= RCC_CCIPR_FDCANSEL_PLLQ
-
Thanks a lot for your project. Trying to repeat it my scenario where stm32g4 connected only by swd clk&io to the esp32s3-n16r8 module on the custom board. As far as I understand you use Platformio plu…
dm128 updated
6 months ago
-
It seems that the GPIO peripheral is largely the same for all but the STM32F1 family. Still, macros that seem to refer to the exact same thing are named inconsistently, e.g.:
- `GPIO_OSPEEDER_OSPEE…
-
I appreciate all the help this library has done for CAN interface. I'm hoping to use this on a STM32G4 series microcontroller to run CAN through the Arduino IDE. If anyone can advise on what changes I…
-
Just wondering, I've been poking around the repo and don't feel confident putting in a pull request. I imagine there are some behind-the-scenes scripts to harvest data about a chip family.
I have a…
-
Hello Team,
Can we add support for the STM32G4 line of MCU's?
No generic board profiles seem to exist for these at this time.
Regards
-
It would be good to have a checklist in the source file of every example, to ensure people trying to use examples for different chips/boards know what they need to do. This is a VERY common question i…
-
Judging by the docs the stm32g4 has no i2c support in libopencm3. But I need it. Time permitting I'll put it in in the next few weeks.
It would be my first time of contributing to libopencm3. So I …
-
FDCAN1_INTR0_IT and FDCAN1_INTR1_IT are swapped (seems to be an error from the ST), what would be the best way to fix this?