-
Hi, I used this procedure and after compiling, burned the sdcard.img to the SD card, but the stm32mp135d didn't boot up properly!Here is the exception log:
-
Build a version of BBN Marine OS for m5stack CoreMP135
CoreMP135 Is arm based computer 4GB RAM and with many interfaces two CAN bus for NMEA 2000,
RS 485 for NMEA 0183,
Uart for pypilot motor co…
-
On M5 CoreMP135, the "poweroff" command does not shutdown properly. After some time, a reboot occurs.
The "reboot" command works correctly.
There is no difference between buildroot and Debian, and t…
-
**Describe the enhancement:** This has been asked on https://discuss.elastic.co a few times, I wanted to raise this here as well. Official ARM builds would be super useful for many different use cases…
-
**Describe the issue**
I can't start a `Tauri 1.4` because when I launch it I get:
```sh
root@stm32mp1:~# dpkg -i armv7-tauri-helloworld_0.0.0_armhf.deb
Selecting previously unselected package…
-
I've tried on a brand new LMDE installation, just in case.
compilation fails when trying to cross-compile arm-trusted-firmware against STM32MP157A-DK1.
```
albirew@VDS-FUSR9:~/arm-trusted-firmware$…
-
Hey! I posted this to the linux wireless mailing list, but I didn't get much of a response. Hopefully it's not too forward of me to cross post this here, as well.
I am experimenting with an 8822bu …
-
I know the most registers and control flow of stm32h7 peripherals and even I've written some of its peripheral drivers in bare-metal. but I don't know anything about barebox driver model and I don't k…
-
I'm working with OP-TEE 3.16 on STM32MP1 on Linux 5.15.24. The PKCS#11 interface works in principle, but any asymmetric key generation attempts fail with CKR_FUNCTION_NOT_SUPPORTED. I'm using pkcs-11-…
-
I saw your post on /r/embedded and wanted to try this out.
I'm using macOS version 12.0.1.
I saw the other open macOS issue, but mine seems different. When I run gdb-frontend with a gdb executable…