-
1. Stratux version:
2. Stratux config:
SDR
- [ ] single
- [ ] dual
GPS
- [X] yes
- [ ] no
type:
AHRS
- [X] yes
- [ ] no
p…
-
Hi,
I've gotten an Pi zero 2W , the 3.7" E-Ink display with the Driver Hat, programmed the Pi with the 2.03 Version and the display didn't do anything.
Then I programmed a Pi4 with the Stratux 030 V…
-
Hi,
thanks for your great project.
I'm using your OGN tracker together with my Stratux Europe traffic awareness device.
I love the additional option to send P3I (PilotAware) signals.
My Pi…
-
**Issue**
It is often cumbersome to have to open up the Stratux config page at the end of each flight to shut down the Raspberry Pi safely.
**Ideal Solution**
The Stratux AHRS application alread…
-
I installed a 28db gain GPS antenna on my TTGO Tbeam module connected via USB to a Raspberry Pi for Stratux. After a few minutes of use after receiving a position, the TTGO shuts down. I have to reboo…
-
I have a Raspberry PI3 and Jessie light.
uname -a Linux raspberrypi 4.9.24-v7+ #993 SMP Wed Apr 26 18:01:23 BST 2017
I use stratux-setup for the installation and the updates. Everything was working…
-
An EXTREMELY low priority item:
I use AP+Client mode, and sometimes it would be convenient to know the 'client mode' IP address.
Perhaps, adding the IP address on WLAN0 to the main status page, at…
-
1. Stratux version: 1.6r1-eu029
2. Stratux config: Attached as startux_censored.conf.txt to get around github filters. Removed wifi passwords and saved.
SDR
- [ ] single
- [X]…
-
RoscoePi works properly with the Stratux Vk-162 Remote (external) Mount USB GPS receiver but does not work with the Stratux GPYes 2.0 u-blox 8 GPS (internal) unit. Most if not all of the prebuilt St…
-