-
- Využili bychom 6-ti vrstvou desku, abychom minimalizovali zásah do návrhu
- QC a možná i PD (ideálně integrovaný PD Sink IC typu STUSB4500 nebo PD PHY typu FUSB302)
- Nabíjecí/stepdown řešení viz.…
-
I've made a board which uses the STUSB4500 and trying to flash it with a Arduino Duemilanove with SoftWire Wire(A0, A1) but it fails.
```
Press 'f' to flash the configuration ...
Flashing - hang …
-
Hi, I've been debugging my otter Iron for the last couple of days, and after testing everything I can think of and customizing the firmware to try and debug the USB PD profile, I finally worked out th…
-
Hi there,
I'm trying this out on a platform that has the stusb4500 part. Could you tell me how I get it to build the example?
Thanks!
Alex
-
Add USB C and USB PD.
Maybe get rid of xt30, maybe keep it.
Neumi updated
12 months ago
-
Since USB-C is the defacto standard these days, can do 20V @ 5A, and means I don't have to buy more barrel jacks
-
I always try to build everything in my toolbox around the USB-C power supplies so I can have one power supply to rule them all haha :)
If 100W is enough power for the board, I think that is a cool…
ghost updated
2 years ago
-
usb.write(default) So this function is not of much use, there is no way to pass a new set of defaults to it to program the board without rewriting the function in the library.
Would be a lot more u…
-
I programmed the unit to give 20V output and connected it to a supply with a USB meter in between. It properly raised the output to 20V. I unplugged the fpx from the meter but since the meter was pull…
-
For future revisions, perhaps you could consider integrating in a boost converter to supply 24V to the heating element, such that the full 65W of power can be used. Perhaps the space freed by the barr…