-
**Describe the bug**
If I build the blinky sample for nucleo_h723zg using stm32cubeprogrammer runner, and then I connect a J-Link to flash it again through the MIPI10 connector: west flash fails.
…
-
Hi guys,
From the rp2040 datasheet(page 300), there are 2 registers named SWCLK and SWD at the offset of PADS_BANK0_BASE+0x7C and PADS_BANK0_BASE+0x80, right after the register for GPIO29. But there …
-
# Albert Rapp - Recreating the Storytelling with Data look with ggplot
We try to imitate the Storytelling with Data look with ggplot
[https://albert-rapp.de/posts/ggplot2-tips/10_recreating_swd_look…
-
Hey there,
my current development setup looks something like this:
![IMG_4437](https://github.com/user-attachments/assets/20fb5a62-cd63-47fd-a65d-340e64b0a96c)
Since I have the picoprobes attac…
-
I have built it from sources for M0S Dock and the device is not stable. Sometime it freezes during communication but typically it cannot be detached from device and hangs when closing the connection.
…
-
I have drone with I think CH32X family MCU (the markings on MCU are removed) it communicates with panchip XN297LBW for 2.4Ghz can you help me to determine where is SWD pad ? Tnx
-
Hello,
We've been using the *swd_ros2_controller* to run our robot equipped with two (left and right) ezWheels with ROS2, and we're observing a behavior where it appears that the time to reach a…
-
Hi,
I am trying to reflash, using the ST-Link V2.
However, I get the following error:
openocd -f interface/stlink.cfg -f target/gd32e23x.cfg -c init -c "reset halt" -c "flash read_bank 0 ZY-M100_L.…
-
Hi, I have been helping my wife and her colleague to run their analyzes in R and I have made my computer available for this.
It turns out that prepare_swd has created a huge amount of files in the …
-
Hi Peter,
finally the time has come that I was running out of GPIO-Pins on one of MKL17z256VFM4 Projects.
So after a careful check of every I/O I realized that I could use the SWD_DIO and SWD_SCK …