-
Hi, is support for the Sx1278 chip planed?
-
Hi,
I'm getting this library to work very well and am quite happy with it. However, I am curious on what the DIO1 through 5 can be used for. Indeed, when starting `LoRa` one can set the callback p…
-
I am using a Hope RFM95 (915 Mhz), spread factor 10, default bandwidth, module soldered onto a ESP8266 plate with resistors removed and SMA connector soldered onto the plate.
I read other peoples …
-
We currently hardcode `boost_if_possible` as `False` in `LorawanRadio:tx(...)`, but this should be handled via "board configuration" as it depends on the board layout and disabled boost might mean no …
plaes updated
5 months ago
-
I have tried to run the following example https://github.com/Xinyuan-LilyGO/LilyGo-LoRa-Series/blob/master/examples/ArduinoLoRa/LoRaSender/LoRaSender.ino, but on `LoRa.endPacket();` program stuck …
-
**Describe the problem you have/What new integration you would like**
Add support for LoRa WAN protocol like RFM95
**Please describe your use case for this integration and alternatives you've …
-
The TCXO control voltage is hard coded in set_oscillator to be 1.7V, but it's normally configurable because different radios use different voltages.
It would be nice to have it controllable.
I'm…
-
Like in https://github.com/jgromes/RadioLib/issues/385 (which was fixed in https://github.com/jgromes/RadioLib/commit/9d3807168f0cfed6b2e7e18644b13ee8c549be38) useRfo is needed in other Lora chips whi…
-
I was able to compile fine, but when I run:
sudo PORT=/dev/ttyUSB0 make flash
It looks like it's trying to flash the Evil Crow. Lights on it are blinking. Then, I get this: Any ideas what I'm do…
-
Hi,
I would like to use your software to integrate a Bresser 9602510 (5in1) sensor via MQTT into my system.
I can't get it to work. I already stopped after "Starting execution..."
I followed your…