-
Hi, is support for the Sx1278 chip planed?
-
Hi,
i've been testing and sending data from T-Beam V1.1 without a problem if the data size is below approx. 200 bytes. If I exceed somewhat around the 200 bytes the packet is not transmitted (or re…
-
Hi,
I'm getting this library to work very well and am quite happy with it. However, I am curious on what the DIO1 through 5 can be used for. Indeed, when starting `LoRa` one can set the callback p…
-
Hi sandeepmistry, are there any chances that you will implement CAD function for the LoRa receiving side so that it can support multiple spreading factors on a single channel?
-
I am using a Hope RFM95 (915 Mhz), spread factor 10, default bandwidth, module soldered onto a ESP8266 plate with resistors removed and SMA connector soldered onto the plate.
I read other peoples …
-
We currently hardcode `boost_if_possible` as `False` in `LorawanRadio:tx(...)`, but this should be handled via "board configuration" as it depends on the board layout and disabled boost might mean no …
plaes updated
6 months ago
-
**Describe the problem you have/What new integration you would like**
Add support for LoRa WAN protocol like RFM95
**Please describe your use case for this integration and alternatives you've …
-
### Category
Other
### Hardware
Rak4631
### Firmware Version
2.5.8.2ba72c15
### Description
When trying to compile customized firmware (using a fresh clone of the master branch) for a device _b…
-
I have tried to run the following example https://github.com/Xinyuan-LilyGO/LilyGo-LoRa-Series/blob/master/examples/ArduinoLoRa/LoRaSender/LoRaSender.ino, but on `LoRa.endPacket();` program stuck …
-
The TCXO control voltage is hard coded in set_oscillator to be 1.7V, but it's normally configurable because different radios use different voltages.
It would be nice to have it controllable.
I'm…