-
Hello,
I've seen your project on arduino and I wanted to port this project on M5 Stack (Espruino) and syn115 RF433 Emitter.
I'm a very beginner with coding Arduino and Unfortunately my project doe…
-
Library support device SYN115/F115?
-
Setup:
Node A: rc-switch sender
https://pastebin.com/dajLZSe3
Node B: rc-switch receiver
https://pastebin.com/RG29GGrs
My Problem is that the sending Node A sends the message **22 times** (…
-
Hi Walter,
Just want to say thanks for sharing your code to receive Somfy RTS signals.
It took me 5 minutes to convert your PlatformIO code to Arduino. Compiled it for an ESP8266 WemosD1Mini and…
-
Hi there,
I bought the following magnetic door/window sensors from Alieexpress.
https://de.aliexpress.com/item/1005006306150712.html
The have a different (maybe newer) board layout and sensor.
Bu…
-
Hello n0xa :)
I highly admire what you're doing, and i am really hoping you could take a look at some of the modules/hats, i found for the m5stick, that you can connect all at the same time, using …
-
Hello, where I should add modulation support code for squareroot2 modulation.? (I have not yet looked your codes at all).
I have esp32 + sym115 chip which I drive with 1/sqrt2 modulation and like t…
-
Hi,
First I must say great project, with this library I was able to integrate some Prologue sensors with ESPHome in HomeAssistant.
Yet I do have some questions if I may.
According to [the docum…
-
Hello IMXNOOBX :)
I highly admire what you're doing, and i am really hoping you could take a look at some of the modules/hats, i found for the m5stick, that you can connect all at the same time, us…
-
I made a very similar (almost identical) board using the SYN115 following the data sheet as you appear to have done, however I made the 315mhz version of the board. After testing my transmitter and re…