-
Hi!
I have just received my new PTS200 soldering iron. It also supports TS100 soldering tips, it has buttons, display, accelerometer, USB PD and QC support, and an open soucre firmware. It is so si…
-
Hello,
I successfully installed your DFU bootloader on 3 TS100, then I bricked my TS80P :sweat_smile: (flash was locked, now fixed with a st-link) but I've an issue with the MHP30: original bootloa…
-
**Is your feature request related to a problem? Please describe.**
TS100 going into thermal runaway constantly while soldering with low voltage power sources i.e. 3s LiPo. This makes soldering in the…
-
Hello, I bought a ts100 and it worked, but I decided to update the firmware and then it did not run anymore and when I connect it to the computer I do not get the config folder, can it not be included…
-
I happens to buy a ts100 with broken firmware, after connecting it to pc it wasn't able to install driver, like the data lines was broken (they're not). So after some research i bought a St-link v2, b…
-
**Describe the bug**
I'm getting weird standby temperature readings on my TS100, off by 100+°C.
What's event weirder is that the temperature reading varies considerably based on the input voltag…
-
Multiple ts assigned to the same volId (ts100,101...121 are matched to volId 9 but there are others that are matched fine)
Review the matching:
It should be done by the tilt series name first …
-
Hi, I seem to have bricked my TS100 using release 0.2. I'm not sure what's gone wrong since everything seemed to proceed as in the instructions. I first installed `runtime.hex` using stock mass storag…
-
Any chance you'll sell these mainboards on Tindie or another similar storefront? I'd love USB-PD on my TS100 but I lack the ability to do fine pitched SMD soldering.
-
Soo..... This code should now be into the territory of testable.
I've tested on 3x TS100's so far.
To test still:
- TS80
- TS80P
- MHP30
If anyone out there wants to give it a shot to just…