-
Hi!
I am testing the software with a 1130:660C model (ID 1130:660c Tenx Technology, Inc. Foot Pedal/Thermometer / USB HID v1.10 Device [ PCsensor Temper]). However, I get "Found 0 devices". There is …
-
I'm leaning towards using SPI directly (rather than USB) for interfacing Lepton 3.5 in a future hardware revision.
* It would bring down the cost of the device (the GroupGets Purethermal board cost…
-
## Expected Behavior
Collect data from Tasi TA612C ( http://www.china-tasi.com/plus/view.php?aid=97 )
## Actual Behavior
Construct the roasting curve with channels on BT, ET and third reading lik…
-
I've compiled the code and tested it with my new usb thermometer (as above) and it is working with the current code:
~/Development/usb-thermometer/TEMPered/build/utils$ sudo ./tempered
/dev/hidraw2 …
-
Hi
I narrowed down the problem to level shifters and I2C.
I2C doesn't work through TXS0108E. I have successfully connected the ESP32 board to STC over I2C and it is working perfectly turning the two…
-
I get the following error when trying to flash boot.
Tried different baud speeds and v16 vs v17 same error.
```
=========================================================
PHY62x2 Utility version …
-
My thermometer does not connect via BLE. The connection keeps breaking. I have tried different browsers and devices. Even with new batteries it does not work.
Are there any instructions on how to fla…
-
I use a half dozen Xiaomi LYWSD03MMC temperature sensors with Home Assistant, they work well. I have an [XDO bluetooth 5.0 adapter](https://www.amazon.com/Bluetooth-XDO-Wireless-Transmitter-Headphones…
-
Thanks for the sw. I ordered a couple of single pedal switch from eBay, and when the first one arrived, I was able to configure it with footswitch without any problems.
Some time later I got the othe…
-
Hi there!
Using this conf file (built off the one provided - /config/rtl_433/rtl_433.conf - password section)
Version: ` 2024.6.0`
```
## version 2024.3
report_meta stats
report_meta t…