-
https://www.amazon.com/JESSINIE-Serial-CH340N-Upgrade-Download/dp/B0CLD1THZ1
-
Is there any way to do so?
I'm able to change baudrate in the source code.
And say communication program to set specific baudrate (picocom).
But it seems 115200 is the only working setup.
It's…
-
Hi,
I lost the encryption key for esphome when I lost the previous HA config. The droplet gets reconized on the new install but I can't give it access to integrate without this key so I'm trying to…
-
### The problem
Since around 2024.04 two configured UARTs on a S2 Board will fail to boot.
It was working OK until 2024.03.
It is working with Arduino IDE
If either of the two UARTs is removed…
-
I don't know the details yet, but it spams `error -71` in dmesg. Will investigate with picoprobe later.
-
### The problem
ESP-IDF not handling the usb-cdc option.
Works with `type: arduino` just not `type: esp-idf`
### Which version of ESPHome has the issue?
DEV
### What type of installation are yo…
-
Hi,
I am trying to run wasm code on Pico through wamr and Zephyr by using command "west build -b rpi_pico -p always -- -DWAMR_BUILD_TARGET=THUMB"
It works. However after flashing the .uf2 file i…
-
2.7 test case:
```Java
public static void main(String... args) {
SerialPort[] commPorts = SerialPort.getCommPorts();
System.out.println(commPorts.length + " comports found.");
for (Ser…
-
As with telnet, is there a way to use the UART or the USB port for serial communications allowing for config changes.
-
### Board
YD ESP32-S3 devkit (clone)
### Device Description
devkitc1 clone
n16r8
### Hardware Configuration
Another devkit clone linked via gpio 1,2
### Version
other
### IDE Name
Platform…