-
Hi @LilyGO -
How do you power the T-Encoder through the T-Encoder-shield VBus?
I get 3V from the VBus here:
But low amps, which is not enough to run T-Encoder from the shield.
-
ESD diodes are needed on the USB data and VBUS
-
I have an active barcode reader as a HID device working in presentation mode with the shield and working well.
I tried **Usb.vbusPower(vbus_off);** to try to turn the power to the device off so to sa…
-
There is a slight leakage from the Pico W to the VBUS when running on battery power, exceeding the USB's **vSafe0V** by 0.8V, and sometimes the host PC-side USB controller may not supply power to the …
oyama updated
4 months ago
-
Hi,
I can see the in block diagram(DS-012 V6X standard) ADIO(8pin JST GH) 3 bits for bootloader. I couldn't figure out corresponding 3pins used for boot loader in pinout sheet. but i can gues…
-
I'm getting a message saying vbus request failed. I can bypass it and control the motor normally using the code in the example sketch.
I am using a Teensy4.1 with an odrive S1.
Example output:…
-
I have installed the hass-Deltasol-KM2 custom component with associated Resol-VBus json live data server addon. The addon seems to be functioning, but I get an error indicating an incorrect password.…
-
This issue is spawned from the Sparkfun forum post [here](https://forum.sparkfun.com/viewtopic.php?p=249708#p249708).
I've noticed the [Thing Plus USB-C](https://www.sparkfun.com/products/20168) ha…
-
Соеднить USB VBUS с PA9
-
I've built one of these and I am getting -12 and 5v on the header, but 4.9v on the +12. I checked the power coming from pin 1 on the IC, and its 1.3v (?) but 4.6v on the VBUS pin on the other side of …