-
Currently the MK4duo firmware does not support the Velleman Vertex Delta K8800 Printer. Would it be possible to add this printer to the branch?
Velleman supplies a full schematic of how the ATMEGA2…
-
### Version
2.3.0-beta.2
### Operating system type + version
Ubuntu 20
### 3D printer brand / version + firmware version (if known)
Any delta printer as far as I know of, in my case the Anycu…
-
Hello,
I installed the repetier firmware on my tronxy X1.
Everything works fine besides two things:
1: the extruder stepper doesn't move.
2: while connected via USB the printer resets every 10 se…
-
Hi,
When I want to start printing with USB mode, nothing happend on the printer because cura doesn't send any temperature order for the extruder (0°C.
A temperature (205°C) is set for this material …
-
This is a catch-all for all "me too" configuration requests. If you can submit partly or fully working configs for printers we don't yet support, please do, as we rely on owners of machines to test an…
-
I have everything working normally using repetier host 0.82b and repetier firmware 0.71 on Generation 6 electronics..... except one problem... If I use the flowrate at all, even a small amount, my X a…
-
http://3dprintboard.com/showthread.php?15326-Qidi-Tech-1-Replicator-2-clone&p=94492&viewfull=1#post94492
Please refer to the link above, and read through a few pages of posts. I have been suffering f…
-
During large probing sessions the back move is apparantly not executed correctly and motion continues to bed. Popping probe up to inactive state. (In this state it reports H as if it was triggered.)
…
-
Hi! I've stumbled upon your project, and after compiling the "models" test, it's quite impressive work!
I've read in some old forum post that this uses a custom model format tailored specifically f…
-
**Application version**
Cura 4.4.0
**Platform**
Windows 10 64 bit
**Printer**
ANET A8, Sidewinder X1
**Reproduction steps**
Slicing a cylinder like object
![grafik](https://user-ima…