-
I've built a flight controller with arduino nano and nrf24l01 PA LNA module this is the code for reciever
```
#include
#include
#include
#include
int ch_1 = 0;
int ch_2 = 150;
int ch_3 =…
-
### Build platform
Linux
### Core version
current 'main' branch
### Target
CH32V30x_EVT
### To reproduce
Make an empty sketch like that:
```
#if defined(DEBUG)
#error DEBUG is defi…
-
I would like to know the status of programming over the serial interface.
Is it possible? If not, is support planned?
Are there any Linux CLI tools that have this function?
I have not been able t…
-
When installing, or updating to, version 1.0.4, the installation fails when using Windows (11), with the following console output:
```
Tool WCH:riscv-none-embed-gcc@8.2.0 already installed
Tool…
-
Your README says:
> Then you can search for "wch" through the "board manager", find the installation package, and install it.
In fact searching for WCH doesn't find it. You need to search for "C…
-
Although the MCU-Flash-Tools are intended for usage with the WCH-LinkE, it appears to be relatively easy to get them to function together with the WCH-LinkW.
rvmode.py and chprog.py work together w…
-
CH330/340 and CH376 have less than stellar datasheets. This is an issue to check on this at the next major release and see if better English datasheets are available.
-
The chip has 62K as other in x035 series.
62K is mentioned in pdf files and x035 page desciption (WCH website), same time chips list page says it is 48K, that
seem to be typo.
```c
{
…
-
I have on board MCU without marking on it the VDD and GND maches to CH32X033F8P6 or CH32X035F7P6
so is there a way to determine do I have CH32X033F8P6 or CH32X035F7P6 on my borad ? TNx
-
I am using the CH32V00x configuration when compiling. Programming goes fine. Log:
```
Info : WCH-LinkE mode:RV version 2.12
Info : wlink_init ok
Info : clock speed 6000 kHz
Info : [wch_riscv.cp…