-
esp. for macOS users.
-
I saw the same problem( #1121)
in use Ubuntu (Linux w-VirtualBox 5.19.0-46-generic #47~22.04.1-Ubuntu SMP PREEMPT_DYNAMIC Wed Jun 21 15:35:31 UTC 2 x86_64 x86_64 x86_64 GNU/Linux)
When I run pyoc…
-
here are the last lines:
```
14:30:19 [INFO] Now connect to the WCH-Link serial port to read SDI print
er computer software
```
(found these lines in the end of WCH-LinkE-APP-IAP.bin)
-
Hi,
After installing for VSCode as per instructions I was able to build but not flash firmware (noneos-sdk) because of libusb not being found. This despite having both Homebrew and MacPorts instanc…
scomx updated
3 weeks ago
-
When installing, or updating to, version 1.0.4, the installation fails when using Windows (11), with the following console output:
```
Tool WCH:riscv-none-embed-gcc@8.2.0 already installed
Tool…
-
Context:
```
[INFO] Connected to WCH-Link v2.9(v29) (WCH-LinkE-CH32V305)
[INFO] Attached chip: CH32V30X [CH32V307VCT6] (ChipID: 0x30700528)
```
If the CPU is halted with:
```wlink halt```
…
-
I am using the CH32V00x configuration when compiling. Programming goes fine. Log:
```
Info : WCH-LinkE mode:RV version 2.12
Info : wlink_init ok
Info : clock speed 6000 kHz
Info : [wch_riscv.cp…
-
Hi, I have an issue when I try using command `wlink status`. How can fix this issue?
```
16:26:11 [INFO] Connected to WCH-Link v2.11(v31) (WCH-LinkE-CH32V305)
Error: WCH-Link underlying protocol er…
-
I've been working on an ALTREP "view" class, and have discovered a number of small places where I think base R itself could be a little more ALTREP friendly. I'd be interested in working on a few of t…
-
Hi!
There are CMSIS-DAP v2 adapters from China that works with openocd
```
[40975.589210] usb 1-3: USB disconnect, device number 12
[40984.609307] usb 1-3: new full-speed USB device number 13 …