-
Hi!
I'm testing the following code as a link between https://sourceforge.net/projects/qmodmaster/ and https://pypi.org/project/pyModSlave/. As hardware, I'm using a NodeMCU 1.0 and a USB/TTL conver…
-
sorry to open ticket for my question but honestly I couldn't figure out which part of your code would be help me out, actually I intend to use my special webserver-websocket program(Arduino IDE) in th…
-
Hi.
Ill try to make a bridge for RTU to TCP but when i use the modbus poll, to check the Modbus TCP, i cant connect with modbus TCP, only with UDP. And i really lost in the port selection, because…
-
Hi, I know it is a serial-wifi bridge. Yet I wonder if it is possible to use a LAN8720 ethernet module and create a serial-ethernet bridge?
Is there, or will there be any support for LAN8720?
-
sorry to open ticket for my question but honestly I couldn't figure out which part of your code would be help me out, actually I intend to use my special webserver-websocket program(Arduino IDE) in th…
-
Add support for the Acer Chromebook 515 Plus - CB515-2H, also known as the Google Omnigul / Brya.
lspci output:
```
00:00.0 Host bridge: Intel Corporation Device 4609 (rev 04)
00:02.0 VGA compat…
-
### Is your feature request related to a problem?
No
### Describe the solution you'd like.
It would be nice to see an example of a native ESP-IDF Wifi to Serial tunnel. This is a very common use-ca…
-
Hi,
Klipper is probably 3D printing's most advanced firmware.
It is a two part system where the hard math is done on a real computer, and the real time stuff is done on a microcontroller.
A s…
-
Build fail:
info: Configuration "sam_d21_xpro_winc1500" will build with toolchain "XC32 v3.01" at "C:\Program Files\Microchip\xc32\v3.01\bin".
warning: Configuration "sam_d21_xpro_winc1500" refers…
-
**Describe the bug**
When I switch from default to hybrid and reboot,the hdmi output device dissapears.Using `sudo envycontrol --reset` and rebooting,makes the device back again
**To Reproduce**
…