-
Testing XM125 modules on custom PCBs to break out pins.
Connected via UART.
Flashed the latest .bin file ok to two modules - one module flashed using the tool, another using STM32Cube. (server_a…
-
Hi, I want to get clarification regarding the services available on XE132. After reading the official documentation, I realized the IQ mode is available for Acconeer A111 sensor. However, when I try t…
JCJC7 updated
2 years ago
-
Hello, This is not a bug. This is a problem I am facing. I am trying to use the Exploration tool with XM132 Module alone. I am not using XE132 EVK. ` acc module server.bin ` is flashed on the module …
-
I am trying to connect XM132 and XM112 via UART. In the Exploration GUI, both ports show up but fail to connect. Both of them work fine on Linux though.
Here's a snippet of the error with xm112 wit…
-
I bought a couple XM132, and trying to use STM32CubeProgrammer to program them, one failed, is there any way to diagnose this and figure out whether it is a hardware failure or software failure?
-
I am trying to switch between two configurations for the envelope service on the XM132. I want to grab one full envelope for each configuration and stitch them together.
Running the acc_module_serv…
-
I have a custom board layout with a host MCU STM32 interfacing with the XM132 module over UART.
The firmware running on the STM32 has a configuration sequence at startup to configure the XM132.
…
-
What hardware, connector and software can we use to program the binary for the XM132 using SWD 10-pin header on the development board?
-
Dear community,
I have the XE132/XM132 entry module. I have followed the instructions to first flash the module. When I connect the device to the laptop using the micro USB cable (the power switch …