AJ6CU 32bit-Raduino-Board_Designs issues

AJ6CU / 32bit-Raduino-Board_Designs

Extends the uBitx Raduino design for newer generations of MCU

GNU General Public License v3.0

5 stars 1 forks source link

issues

Newest

Newest Most commented Recently updated Oldest Least commented Least recently updated

Pico (and perhaps other) LCD display that supports SPI displays using wrong pins

#18 AJ6CU opened 1 year ago
0
PTT header not what it was supposed to be...

#17 AJ6CU opened 1 year ago
0
spi header should be order of data lines

#16 AJ6CU opened 1 year ago
0
on pico v6 (and probably 3-5, swap encoder B and encoder A pins to be consistent with rest of world.

#15 AJ6CU opened 1 year ago
0
add header for spi bus to support air lift.

#14 AJ6CU closed 1 year ago
2
teensy add support for pins on underside of the board

#13 AJ6CU closed 1 year ago
1
move the fbutton on pico to gpio28_ADC2 to allow use of extended button feature of KD8CEC

#12 AJ6CU closed 1 year ago
1
LCD en/rs pins vary depending on state of jumpers

#11 AJ6CU closed 1 year ago
1
LCD en/rs pins not the same on all boards

#10 AJ6CU closed 1 year ago
4
boards sit too low for V6 and use of LCD

#9 AJ6CU closed 1 year ago
1
for all in 1 on v6, need to move LCD header and 7805 to match V6 Raduino

#8 AJ6CU closed 1 year ago
1
For V6 all-in-one need to make it higher and match lcd mounting

#7 AJ6CU closed 1 year ago
1
Version 1.2

#6 AJ6CU closed 2 years ago
0
Signal paths around the SI5351are crowding it an could lead to interference and/or noise.

#5 AJ6CU closed 2 years ago
1
Voltage Hi input too far away from volume put.

#4 AJ6CU closed 2 years ago
1
wrong footprint for LM358DR

#3 AJ6CU closed 2 years ago
1
s-meter chip footprint too small for human soldering

#2 AJ6CU closed 2 years ago
2
RX/TX and D8/D9 do not agree.

#1 AJ6CU closed 2 years ago
1