The most important thing is to insert the POD DISPLAY card !!! that was the problemHi, I´ve got the same problem.

ANYCUBIC-3D / Vyper

Firmware of Anycubic 3D printer Vyper

GNU General Public License v3.0

106 stars 60 forks source link

The most important thing is to insert the POD DISPLAY card !!! that was the problemHi, I´ve got the same problem. #12

Open rom119 opened 2 years ago

rom119 commented 2 years ago

Hi, I´ve got the same problem.

How to solve this:

Use the Micro-SD-Card an fomat as in the README told. Use FAT32 and 4096 Bytes!!! Then copy the DWN_SET to the SD-Card. Without Power put the SD-Card Chip-Side up in the bottom of the Display. Now power up. The update-procedure will take about 2 min (on my machine)

Kind reagards

Frank

Originally posted by @1800Power in https://github.com/ANYCUBIC-3D/Vyper/issues/7#issuecomment-962612780

rom119 commented 2 years ago

The most important thing is to insert the card !!! under DISPLAY !!! that was the problem !!!

chinamummy commented 2 years ago

same problem.